Gas or Oil Heating and Air Conditioning Service Plans for Rhode Island
We offer two great service plans, Gold and Silver, for Gas Heat, Oil Heat and A/C. Choose the one that fits your needs!
Gold & Silver Comfort Plans for A/C
Gold & Silver Comfort Plans for Gas Heat
Gold & Silver Comfort Plans for Oil Heat
Plans are also offered for:
- oil-fired water heaters
- additional heating/cooling unit
- whole-house humidifier
- air cleaner
- oil tank protection
Please contact McKee for these plans and to review the Terms and Conditions of the ALL Service Plans.
Silver Total Comfort Plan
The Silver Plan offers you basic protection.
- annual precision tune-up
- 15% off repairs
- priority service
- 50% off diagnostic fee
- 15% off overtime charges
Gold Total Comfort Plan
The Gold Plan provides total protection, covering almost anything that’s likely to go wrong with your cooling system.
- annual precision tune-up
- free repairs*
- priority service
- no diagnostic fee
- no overtime charges
*McKee Brothers Oil will repair or replace, during the life of this agreement, at no extra charge, all of the parts listed below, which may become defective due to normal use or wear and tear. (Parts not listed may be eligible for a 15% discount.)
Gold Plan Parts Covered:
accumulator, blower motor, blower pulley, blower wheel, condensate pump, condenser fan, condenser fan blade, condenser fan motor, condenser motor, contactor, crankcase, heater expansion valve, high pressure control, holding relay, low pressure control, motor protector, motor starter, outdoor fan blade, outdoor fan motor, outdoor unit relay, potential relay, running capacitor, standard air filter, starting capacitor, starting relay, thermostat, thermostat subbase (standard), time delay control, timer relay, transformer, wiring in condensing unit
Precision Tune-up
A precision tune-up will be performed once during the service plan term during regular working hours. Please call to schedule. The tune-up includes the following:
- Lubricate all moving parts.
- Install gauges; record operating pressures and temperatures.
- Evaluate condition of air filters; clean and replace with filter supplied by customer.
- Measure refrigerant superheat to fine-tune its charge.
- Flush condensate drain to protect against overflow.
- Inspect outdoor condenser coil; clean if needed.
- Clean and check blower motor (and belt if applicable).
- Test temperature drop at return and supply air; adjust blower speed.
- Safety test all controls for proper operation.
- Meter voltage and amperage in all motors; test for worn bearings.
- Test condition of compressor contacts.
- Inspect start and run capacitors and relays for bulges, rust and leaks.
- Tighten and safety test all wires and connections.
- Inform customer of equipment condition.
Loyalty Credits
For each consecutive year you are enrolled in our Gold or Silver Total Comfort Plan, you earn $50 in Loyalty Credits. You can accumulate up to $500 in credits and apply them to the following equipment purchased from us.
- boiler $500
- furnace $350
- central a/c system $250
- heat pump $350
- humidifier/aircleaner $100
A maximum of $50 in Loyalty Credits is awarded each year, regardless of how many service plans you have.
Silver Total Comfort Plan
The Silver Plan offers you basic protection.
- annual precision tune-up
- 15% off repairs
- priority service
- 50% off diagnostic fee
- 15% off overtime charges
Gold Total Comfort Plan
The Gold Plan provides total protection, covering almost anything that’s likely to go wrong with your heating system.
- annual precision tune-up
- free repairs*
- priority service
- no diagnostic fee
- no overtime charges
*McKee Brothers Oil will repair or replace, during the life of this agreement, at no extra charge, all of the parts listed below, which may become defective due to normal use or wear and tear. (Parts not listed may be eligible for a 15% discount.)
Gold Plan Parts & Services Covered
single aquastat, circulator relay, combination control, draft regulator, emergency switch, high limit control, low limit control, pressuretrol, primary control, pyrostat, reverse aquastat, thermostat (manual), triple aquastat, fan inducer motor, flue damper, flue pipe, isolated gas pipe, air valve, burner orifice, burner tube, gas valve, gas valve orifice, low voltage, transformer, pilot burner, pilot tube, pressure switch, purge valve, sensor, sensor ignition, module thermocouple, blower belt, blower motor, blower motor pulley, fan and limit control, altitude and temperature gauge, circulator couplin,circulator impeller, circulator motor, circulator motor mount, circulator wicking, drain expansion tank, drain tubing to condensate, bleed radiators, purge heating system
Precision Tune-up
A precision tune-up will be performed once during the service plan term during regular working hours. Please call to schedule. The tune-up includes the following:
- Perform efficiency test.
- Clean and adjust burners and inspect heat exchanger.
- Check thermostat operation.
- Lubricate all motors, bearings, fans and circulator pumps.
- Clean pilot assembly. Install one 1-inch filter.
- Test and adjust operation of safety and operating controls.
- Inspect flue pipe and gas valve.
- Clean and check blower motor (and belt if applicable).
- Test and tighten all wiring and connections.
- Turn exposed dampers to heating position if marked (no balancing).
- Flush condensate drain to protect against overflow.
- Check temperature rise. Check fan speeds.
- Check gas pressure at gas valve.
- Inform customer of equipment condition; recommend necessary repairs.
Loyalty Credits
For each consecutive year you are enrolled in our Gold or Silver Total Comfort Plan, you earn $50 in Loyalty Credits. You can accumulate up to $500 in credits and apply them to the following equipment purchased from us.
- boiler $500
- furnace $350
- central a/c system $250
- heat pump $350
- humidifier/aircleaner $100
A maximum of $50 in Loyalty Credits is awarded each year, regardless of how many service plans you have.
Silver Total Comfort Plan
The Silver Plan offers you basic protection.
- annual precision tune-up
- 15% off repairs
- priority service
- 50% off diagnostic fee
- 15% off overtime charges
Gold Total Comfort Plan
The Gold Plan provides total protection, covering almost anything that’s likely to go wrong with your heating system.
- annual precision tune-up
- free repairs*
- priority service
- no diagnostic fee
- no overtime charges
*McKee Brothers Oil will repair or replace, during the life of this agreement, at no extra charge, all of the parts listed below, which may become defective due to normal use or wear and tear. (Parts not listed may be eligible for a 15% discount.)
Gold Plan Parts & Services Covered
aquastat, altimeter gauge, blower circuit board, burner mount relay, circulator relay, combination control, double aquastat, draft regulator, emergency switch, fuses, high limit control, low limit control, pressuretrol control, primary control, reverse aquastat, stack control, temperature gauge, thermostat (manual), toggle switch, triple aquastat, triple aquastat relay, fill cap, Firomatic valve, flare fittings, fuel filter cartridge, fuel filter cartridge gasket, fuel filter, complete, fuel pump, fuel pump bleeder, fuel pump couplings, fuel pump fittings, fuel pump gasket, fuel pump seal, fuel pump strainer, oil tank gauge, oil tank vent alarm, vent cap, air diffuser, air filter, air regulator, air stat, blower bearings, blower belt, blower, complete, blower fan, blower fan belt, blower pulley, blower shaft, blower wheel, fan control, humidistat, limit control, automatic air vents (boiler), automatic water feeder, bearing assembly, circulator, complete, circulator coupling, circulator impeller, circulator motor, circulator motor mounts, circulator switch, expansion tank, feed valve, gauge glass, glass gauge washer and nuts, low water cut-off, float, low water cut-off switch, pop safety valve, pressure reducing valve, relief valve, System 2000 manager, zone valve, complete, zone valve motor, zone valve power head, zone valve relay, zone valve stem, burner blast tube, burner coupling, burner fan, burner flange gasket, burner motor, burner switch, cad cell assembly, cad cell eye, cad cell wires, delayed oil valve, delayed oil valve coil, electrode assembly, electrode wires, electrodes, end cone, ignition leads, ignition transformer, low voltage, transformer, nozzle, nozzle adapter, nozzle assembly, nozzle line, porcelain insulators, solenoid valve, turbulator, anti-hum device, barometric dampers, flue pipe, drain expansion tank, bleed radiators, purge heating system
Precision Tune-up
A precision tune-up will be performed once during the service plan term during regular working hours. Please call to schedule. The tune-up includes the following:
- Clean heating unit, vent pipe and chimney base.
- Adjust burner for maximum efficiency.
- Clean and adjust electrode and nozzle assembly.
- Lubricate all motors, bearings, fans and circulators.
- Replace oil nozzle and oil filter.
- Test and adjust all safety and operating controls.
- Inspect flue pipe, barometric damper and combustion chamber.
- Test oil pump operation.
- Change air filter(s),
- if applicable. Check oil tank and lines.
- Inform customer of equipment condition.
Loyalty Credits
For each consecutive year you are enrolled in our Gold or Silver Total Comfort Plan, you earn $50 in Loyalty Credits. You can accumulate up to $500 in credits and apply them to the following equipment purchased from us.
- boiler $500
- furnace $350
- central a/c system $250
- heat pump $350
- humidifier/aircleaner $100
A maximum of $50 in Loyalty Credits is awarded each year, regardless of how many service plans you have.